Fulton County, New York
Heating and AC repair in Gloversville, NY
Call and describe the problem, whether the furnace will not light, the heat pump is iced over or the air conditioner is blowing warm air, and you will be connected with an independent HVAC contractor serving Gloversville.
Your call is connected to an independent HVAC contractor, subject to availability in your area. HVAC Nation may receive compensation when your call is connected with a participating provider. Providers are independent businesses.
Gloversville at a glance
Heating and cooling climate
NOAA's 1991–2020 climate normals for the GLOVERSVILLE 7NW (PECK LAKE), NY station (about 6 miles away) show about 8,675 heating degree days and 163 cooling degree days in a typical year, with about 179 nights at or below freezing and 0 days reaching 90°F or more. Heating demand is far larger than cooling demand here, so the furnace, boiler or heat pump carries most of the load and a breakdown in a cold snap is the most pressing kind of call.
How homes in Gloversville are heated
According to the Census Bureau's American Community Survey, 76% of occupied homes in Gloversville heat mainly with utility gas and 16% with electricity. Gas-fired furnaces and boilers are the most common setup, which means igniters, flame sensors, gas valves and venting come up often on heating calls.
Housing age and HVAC systems
The median year built for housing in Gloversville is 1938, and about 93% of its 7,655 housing units were built before 1980. Many older homes here were built around hot-water or steam boilers and radiators, and some have had forced-air systems and central air added later, which can mean older ductwork and mixed equipment.
Services most relevant in Gloversville
- Furnace Repair (81% of homes heat with gas, propane or oil)
- Boiler Repair (median home built in 1938)
- AC Repair (163 cooling degree days a year)
- AC Replacement (median home built in 1938, many systems on their second or third AC)
- HVAC Repair (one call when you are not sure which part failed)
Owners, landlords and tenants
About 52% of occupied homes in Gloversville are owner-occupied and 49% are rented. Homeowners, landlords and property managers can call to be connected; tenants should contact their landlord or property manager about heating or cooling problems first.
Nearby places
Gloversville is in Fulton County. Places within about 30 miles include Schenectady (27 mi), Saratoga Springs (29 mi), Amsterdam (11 mi), Johnstown (3 mi) and Scotia (25 mi).
Other New York locations
Poughkeepsie (96 mi), Beacon (109 mi), Oswego (112 mi), Auburn (113 mi), Plattsburgh (122 mi), Peekskill (124 mi), Port Chester (145 mi), Floral Park (164 mi), North Tonawanda (228 mi), Jamestown (257 mi)
Questions
Is HVAC Nation an HVAC company in Gloversville?
No. HVAC Nation is a referral service. Calls from Gloversville are connected to an independent HVAC contractor, subject to availability in Fulton County.
How do most homes in Gloversville heat?
Census survey data shows about 76% of homes heat mainly with utility gas, 16% with electricity, 2% with propane and 3% with fuel oil.
How cold and hot does it get around Gloversville?
NOAA normals for the GLOVERSVILLE 7NW (PECK LAKE), NY station average about 179 nights a year at or below 32°F and 0 days at 90°F or above.
Is a permit needed to replace a furnace or air conditioner in Gloversville?
Many cities and counties require mechanical or electrical permits for equipment replacement. Check with the local building department for Gloversville or Fulton County, and ask the contractor.
What should I do if I smell gas?
Leave the home right away without using switches or phones inside, then call the gas utility emergency line or 911 from outside.
Sources: U.S. Census Bureau Vintage 2024 population estimates; American Community Survey 2020–2024 5-year (tables B25040 house heating fuel, B25034, B25035, B25003); 2024 Gazetteer; NOAA NCEI U.S. Climate Normals 1991–2020 (heating and cooling degree days, base 65°F).